diff options
author | 2018-11-11 00:32:16 +0100 | |
---|---|---|
committer | 2018-11-11 10:17:46 -0800 | |
commit | 787799a9d5557f9494bf79b7052d3b9ee68f3b80 (patch) | |
tree | a23cbae2d1d80da3dab85fdb5bfebc10cb610297 | |
parent | net: dsa: mv88e6xxx: Differentiate between 6390 and 6390X cmodes (diff) | |
download | linux-787799a9d5557f9494bf79b7052d3b9ee68f3b80.tar.gz linux-787799a9d5557f9494bf79b7052d3b9ee68f3b80.tar.bz2 linux-787799a9d5557f9494bf79b7052d3b9ee68f3b80.zip |
net: dsa: mv88e6xxx: Default ports 9/10 6390X CMODE to 1000BaseX
The 6390X family has 8 SERDES interfaces. This allows ports 9 and 10
to support up to 10Gbps using 4 SERDES interfaces. However, when lower
speeds are used, which need fewer SERDES interfaces, the unused SERDES
interfaces can be used by ports 2-8.
The hardware defaults to ports 9 and 10 having all 4 SERDES interfaces
assigned to them. This only gets changed when the interface is
configured after what the SFP supports has been determined, or the 10G
PHY completes auto-neg.
For hardware designs which limit ports 9 and 10 to one or two SERDES
interfaces, and place SFPs on the lower interfaces, this is too
late. Those ports with SFP should not wait until ports 9/10 are up in
order to get access to the SERDES interface. So change the default
configuration when the driver is initialised. Configure ports 9 and 10
to 1000BaseX, so they use a single SERDES interface, freeing up the
others. They can steal them back if they need them.
Signed-off-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
-rw-r--r-- | drivers/net/dsa/mv88e6xxx/port.c | 9 |
1 files changed, 6 insertions, 3 deletions
diff --git a/drivers/net/dsa/mv88e6xxx/port.c b/drivers/net/dsa/mv88e6xxx/port.c index e718404a5e03..ebd26b6a93e6 100644 --- a/drivers/net/dsa/mv88e6xxx/port.c +++ b/drivers/net/dsa/mv88e6xxx/port.c @@ -368,12 +368,15 @@ int mv88e6390x_port_set_cmode(struct mv88e6xxx_chip *chip, int port, u16 reg; int err; - if (mode == PHY_INTERFACE_MODE_NA) - return 0; - if (port != 9 && port != 10) return -EOPNOTSUPP; + /* Default to a slow mode, so freeing up SERDES interfaces for + * other ports which might use them for SFPs. + */ + if (mode == PHY_INTERFACE_MODE_NA) + mode = PHY_INTERFACE_MODE_1000BASEX; + switch (mode) { case PHY_INTERFACE_MODE_1000BASEX: cmode = MV88E6XXX_PORT_STS_CMODE_1000BASE_X; |